Why won't my Zebex Z-3272 Plus Barcode Reader scan barcodes?
Your Zebex Barcode Reader might not be scanning barcodes for a few reasons. First, the scanner window could be dirty; try cleaning it as described in the Maintenance section. Second, the barcode type you're trying to scan might not be enabled. You can select the appropriate barcode type in the Programming Guide. Finally, the barcode type might not be supported by the scanner.
General| Type | Handheld Barcode Scanner |
|---|---|
| Interface | USB, RS-232, Keyboard Wedge |
| Tilt Angle | ± 65° |
| Operating Temperature | 0°C to 50°C |
| Humidity | 5% to 95% (non-condensing) |
| Drop Test | 1.5 m |
| Voltage | 5 VDC ± 5% |
| Light Source | LED |
| Scanning Distance | 30 - 450mm |
| Reading Distance | 30 - 450mm |
| Depth of Field (7.5 mil) | 30 - 150mm |
| Skew Angle | \u00b160 degrees |
| Barcode Types | Code 39, Code 128, Interleaved 2 of 5, Codabar |
| Indicators | Beeper and LED |
| Storage Temperature | -20°C to 60°C |
Instructions on how to perform a test scan to verify scanner operation and configuration.
Outlines the procedure for scanning barcodes to configure scanner settings.
Options to enable, disable, or reset all readable symbologies to default settings.
Step-by-step guide to setting up prefix characters for scanned data.
Step-by-step guide to setting up suffix characters for scanned data.
Configures decoding for symbols with a single specific length using numeric barcodes.
Configures decoding for symbols with two specific lengths using numeric barcodes.
To Next Page
