Adding a New
Transfer Ribbon
If ribbon runs out in the middle of a print job, the
indicator lights orange and the printer waits for
you to add a fresh roll. Keep the power on as
you change ribbon. Open the top cover, then
cut the used ribbon so you can remove the
cores. Load a new ribbon roll (refer to the previ
-
ous procedure if necessary). Close the top
cover. Press the Feed button to restart printing.
Replacing a
Partially Used
Transfer Ribbon
To remove used transfer ribbon, cut the ribbon
from the take-up roll. Remove the take-up roll
and discard used ribbon. Remove the supply
roll and tape the end of any fresh ribbon to pre
-
vent it from unwrapping. When reinstalling a
partially used supply roll, tape the cut end onto
the empty take-up roll.
18 980381-001 Rev. B
Using Options
Cut Used
Ribbon
from Supply
Push Supply
Roll Out
To Next Page
Loading...