Latch Replacement - LP 980358-211A
Protect against static discharge. Your work area must be static-safe and include
a properly grounded conductive cushioned mat to hold the printer and a
conductive wrist strap for yourself.
Open the printer by pulling the release latches forward, then lifting the top cover. Remove media.
Removal
1. Use a #1 Phillips driver to loosen the four
screws 1234 that hold the latch frame !
to the top case ".
2. Detach the springs on both sides from
where they engage the latch frame #$.
3. Unsnap the latch shaft 5 from its bearings
in the frame.
Assembly
1. Make sure the springs are engaged on the
latch handles %&.
2. Align the latch assembly so that the hooks
face the rear. Snap the latch shaft into its
bearings on the frame.
3. Engage both springs into the top hole on the latch frame.
4. Align the latch frame up to the top case and
ensure that the cables are not bent or
pinched.
5. Replace the four screws that hold the latch
frame to the top case and use a #1 Phillips
driver to tighten them.
6. Clean the print head with the cleaning pen.
Assembling the Printer
Reload media. Plug in the power cord, turn on
the printer and run the AutoSense routine to get
a dump mode printout.
980358-001 Rev. B 19
To Next Page
Loading...
Need help?
General
