Need help?Do you have a question about the Zebra 400 and is the answer not in the manual?
Steps for unpacking, reporting damage, and identifying site installation requirements.
Identifies printer types and explains Tear-Off, Peel-Off, and Cutter modes.
Instructions for connecting the printer to a power source.
Detailed procedures for loading media in Tear-Off and Peel-Off modes.
Setting up Peel-Off mode and removing label backing material.
Procedures for loading media in Cutter mode.
Adjusting ribbon spindle, loading, removing ribbon, and instructions.
Adjusting the media sensor for continuous and non-continuous media.
Using printer buttons, LEDs, and performing auto calibration.
Connecting via interfaces, communication settings, and software setup.
Cleaning procedures, cutter module maintenance, lubrication, and adjustments.
Using troubleshooting tables, status sensors, and self tests to diagnose issues.
Details on general, printing, ribbon, media, options, and ZPL II.
Interface technical info, storage, reshipping, and glossary definitions.
To Next Page
General