Lubrication
No lubricating agents of any kind are required on this printer. Some
commercially available lubricants will damage the finish if used.
AC Power Fuse Replacement
A user-replaceable AC power fuse (see Figure 6) is located just to the left of
the power on/off switch. For use with both voltage ranges, the replacement
fuse is a 5x20 fast blow style rated at 5 Amp/250 VAC.
1. Before replacing the fuse, turn the AC power switch off and unplug the
AC power cable.
2. To replace the fuse, insert the tip of a flathead screwdriver into the slot
in the end of the fuse holder end cap.
3. Press in slightly on the end cap and turn the screwdriver slightly coun-
terclockwise. This will disengage the end cap from the fuse holder and
permit the removal of the fuse.
4. To install a new fuse, reverse the procedure.
30 S400 & S600 User’s Guide
38
To Next Page
Loading...
Need help?
General
