Storage and Reshipping
If you are not placing the printer into operation immediately, repackage it
using the original packing materials. The printer may be stored under the
following conditions:
n
Temperature: -40° to 140° F (-40 to 60° C)
n
Relative humidity: 5% to 85% non-condensing
To ship the printer, carefully pack it in a suitable container to avoid damage
during transit. Whenever possible, use the original container from the
factory. A shipping container can be purchased from Zebra Technologies
Corporation, if the original one has been lost or destroyed.
If you use a different container, package the printer carefully to avoid
damage.
CAUTION: When packaging the printer in a rigid container, use shock
mounts or shock-absorbing packing material. A rigid container will allow
shock on the outside to be transmitted undamped to the printer which may
cause damage. Also, before packing, remove all ribbon and media from the
supply and take-up spindles to prevent damage to the printer.
62 S400 & S600 User’s Guide
70
To Next Page
Loading...
Need help?
General
