Contents
Introduction
Unpacking ..................................1
Reporting Damage..............................1
Site Requirements ..............................2
Introduction to Printers ...........................2
Tear-Off Mode ..............................2
Peel-Off Mode ..............................3
Cutter Mode ................................3
Printer Overview ..............................4
Getting Ready to Print
AC Power Cable...............................5
Loading the Media .............................7
Tear-Off Mode ..............................7
Roll Media ...............................7
Fanfold Media .............................8
Peel-Off Mode ..............................9
Removing the Label Backing Material ................10
Cutter Mode ...............................11
Loading the Ribbon ............................12
Ribbon Supply Spindle: Normal Position ................12
Ribbon Supply Spindle: Low-Tension Position .............12
Ribbon Loading Instructions ......................13
Ribbon Removal ..............................14
Adjusting the Media Sensor ........................15
Non-Continuous Media .........................15
Continuous Media ............................15
Auto Calibration ..............................16
Operator Controls .............................16
Front Panel Buttons ...........................16
Front Panel LEDs ............................17
AC Power ON/OFF Switch ........................18
S400 & S600 User’s Guide i
5
To Next Page
Loading...
Need help?
General
