CC600/CC6000 Customer Concierge Quick Start Guide
1
Introduction
This guide provides information regarding unpacking the device, features, setup, mounting, barcode capture, and
resetting the device.
Unpacking
1. Carefully remove all protective material from the device and save the shipping container for later storage and
shipping.
2. Verify that the following are included:
• CC600 or CC6000 interactive kiosk.
• Regulatory Guide.
• CC600 only: Ferrite bead for EMI. Attaches to the DC power module.
3. Inspect the equipment for damage. If any equipment is missing or damaged, contact the Global Customer
Support center immediately.
4. Prior to using the device for the first time, remove the protective shipping film that covers the display.
Features
NOTE: Although the orientations differ, the features on the CC6000 landscape and portrait devices are the same.
Figure 1 CC6000 Front View
Front
Facing
Camera
Touch
Screen and
Display
Speaker
NFC
Antenna
Speaker
Exit Window (Scanner)
Microphone
To Next Page
Loading...
Need help?
General
