Mobile Printer CPCLProgramming Manual P9-3
UNITS Commands
The units commands specify a measurement system for
all subsequent command fields in a utility session. Coor-
dinates, widths, and heights for all utility commands can
be entered with precision to four decimal places. The
printer measurement system will default to dots until a
units command is issued.
Format:
<!> <UTILITIES>
{command}
<PRINT>
where:
{command}:
Choose from the following:
IN-INCHES Measurement in inches.
IN-CENTIMETERS Measurement in centimeters.
IN-MILLIMETERS Measurement in millimeters.
IN-DOTS Measurement in dots. The
default unit of measurement is
in dots.
To Next Page
Loading...