Mobile Printer CPCLProgramming Manual P9-9
SETSP Command
The SETSP command is used to change spacing
between text characters. Spreading out characters on a
line
makes the font appear wider. The SETSP command
can also be used to spread out the text across the line.
! U1 SETSP {unit to separate characters}
For example, “! U1 SETSP 5” will put five dots between
each character on the line. Try this command to make
fonts look larger for emphasis. Note that this command
is affected by the UNITS command setting. (Refer to the
SETBOLD command above.)
Example:
Normal Text ! U1 SETSP 5
SPREAD OUT TEXT
To Next Page
Loading...