Zebra CPCL - SETFF Command

Mobile Printer CPCLProgramming Manual P9-11
SETFF Command Example
The following example programs the printer to advance
the paper until the eye-sense mark is found, or the paper
has been advanced a maximum of 25 millimeters. If an
eye-sense mark is found, the paper will be advanced an
additional 2.5 millimeters.
Input (SETFF.LBL):
! UTILITIES
IN-MILLIMETERS
SETFF 25 2.5
PRINT
SETFF Command
The SETFF command is used to align top of media to
printhead. Once this command is executed, the align-
ment will occur when :
• feed key is pressed.
• form-feed character (0x0c) is issued.
• FORM command is issued.
Format:
<!> <UTILITIES>
{command} {max-feed} {skip-length}
<PRINT>
where:
{command}: SETFF
{max-feed}: Maximum unit-length the printer
advances searching for the next eye-
sense mark to align top of form. Valid
values are 0-20,000.
{skip-length}: Unit-length printer advances past top
of form. Valid values are 5-50.