Zebra CPCL - ANNOUNCE Utility

P10-12 Mobile Printer CPCLProgramming Manual
ANNOUNCE Utility
The ANNOUNCE command is used to activate pre-
programmed sounds in the printer. A space character is
required between each code. This command will be
ignored by printers that are not equipped with a speaker
and voice circuit.
Format:
<!> <UTILITIES>
{command} {message}
<PRINT>
where:
{command}: ANNOUNCE
{message}: Choose from the following:
Code: Spoken Messages:
' ' pauses between sounds
'.' "point"
'0' "zero"
'1' "one"
'2' "two"
'3' "three"
'4' "four"
'5' "five"
'6' "six"
'7' "seven"
'8' "eight"
'9' "nine"
'^' "version"
'{' "go to aisle"
'|' "latch is open"
'}' "battery is low"
'~' "out of paper"