Zebra CPCL - BHT-PROTOCOL Command

Mobile Printer CPCLProgramming Manual P10-53
BHT PROTOCOL Command
This command placed in an autoexec. bat file overrides
the default method of communication.
BHT-PROTOCOL CABLE enables BHT or BHT-IR proto-
col via cable. If the BHT-PROTOCOL CABLE command
is
not present, data is sent "raw" over the serial cable, if it
is detected the BHT-PROTOCOL BHT command sends
data in the BHT mode; BHT-PROTOCOL BHTIR sends
data in the BHT-IR mode.
Format: {Command} {mode}
where:
{Command}: BHT-PROTOCOL
{mode}: BHT
This mode establishes that data will be
sent in BHT protocol mode
CABLE
This mode enables BHT or BHT-IR
protocol via cable. If the BHT-PROTO-
COL CABLE command is detected the
BHT-PROTOCOL BHT command sends
data in the BHT mode
BHTIR
Sends data in the BHT-IR mode.
continued