Mobile Printer CPCLProgramming Manual P12-1
WIRELESS NETWORK PRINTERS
Introduction
Zebra Cameo 3N and Encore 3N Network Printers are
equipped with a WLAN (Wireless Local Area Network)
card. Network printers allow wireless communication as
a node within a local area network, and its wireless capa-
bilities allow communications from any point within the
LAN’s perimeter.
The following section details commands used with Net-
work Printers to configure various characteristics and to
interrogate the printer for its network settings.
Note: If you are using a WLAN enabled QL series
printer, you should use the “get, set,do” parameters
detailed in Section 14 rather than the LAN command
detailed below.
Network Printer Safety Considerations
WARNING: Use of the Network Printers will result in
exposure to Radio Frequency radiation. To conform to
FCC RF exposure requirements these printers must be
used only in the intended orientation and in the in-
tended manner.
Refer to the User’s Manual for the Network Printer in use
for more specific safety instructions. In all cases, avoid
prolonged exposure closer than 5 cm. (2 in.) to the radiat-
ing area around this unit’s antenna.
LAN Command
Format:
LAN
{ Operation } { Options }…{ Operation } { Options }
The LAN command can be used to interrogate and con-
figure the Wireless LAN (WLAN) card in a Zebra Network
Printer. The entire LAN command must be terminated by
a CRLF pair (0x0D0x0A).
To Next Page
Loading...