P2-6 Mobile Printer CPCLProgramming Manual
UNITS Commands
The units commands are used to specify a measurement
system for all subsequent command fields in a control
session. Coordinates, widths, and heights for all control
commands can be entered with precision to four decimal
places. By placing a units command immediately after
the first line in a control session, the specified measure-
ment system will also apply to the offset and height fields.
The printer measurement system will default to dots until
a units command is issued.
Format:
{command}
where:
{command}:
Choose from the following:
IN-INCHES Measurement in inches.
IN-CENTIMETERS Measurement in centimeters.
IN-MILLIMETERS Measurement in millimeters.
IN-DOTS Measurement in dots.
To Next Page
Loading...