Zebra CPCL - ip.snmp.enable

Mobile Printer CPCLProgramming Manual P14-55
ip.smtp.server_addr
type: getvar; setvar
This parameter refers to the IP address of the SMTP
server used for sending email.
getvar result Returns the IP address of the SMTP server
used for sending email.
Example Description Instructs the printer to respond with
the current SMTP server address.
Syntax ! U1 getvar “ip.smtp.server_addr”
Result “0.0.0.0”
setvar choices Any valid IP address assigned to the SMTP
server.
Default “0.0.0.0”
Example Description Instructs the printer to change the
SMTP server address to
10.10.10.10.
Syntax ! U1 setvar “ip.smtp.server_addr”
“10.10.10.10”
Result Changes the SMTP server
address the printer uses to
send email to 10.10.10.10
ip.snmp.enable
type: getvar; setvar
This parameter refers to the SNMP protocol. Enabling
this parameter will allow the printer to be monitored and
managed remotely via network management programs
supporting SNMP.
getvar result Returns the SNMP status (on or off).
Example Description Instructs the printer to respond with
the SNMP setting.
Syntax ! U1 getvar “ip.snmp.enable”
Result “on”
setvar choices “on”, “off”
Default “on”
Example Description Instructs the printer to disable the
SNMP protocol.
Syntax ! U1 setvar “ip.snmp.enable” “off”
Result Turns off the SNMP protocol.
continued on next page