P14-74 Mobile Printer CPCLProgramming Manual
wlan.international_mode
type: get var; set var
This parameter refers to International mode in 802.11
FH(Frequency Hopping) and 802.11b wireless cards. Set-
ting this parameter to “on” allows a printer to operate in
wireless networks with settings different from standard
US/Canada wireless network settings. Setting this pa-
rameter to “off” instructs printer to operate according to
US/Canada wireless network standards. Two radio cards
are currently supported: Symbol Spectrum24 802.11b
and Symbol Spectrum24 802.11 Frequency Hopping
(FH). Cisco radio cards are not currently supported.
NOTE: This parameter must be set according to the wireless network infra-
structure used. Setting this parameter to “on” for an 802.11b card without hav-
ing active wireless access points with non US/Canada settings stops the
printer from communicating via its 802.11b card. Setting this parameter to
“on” for 802.11 FH radios causes the printer to take an additional 4 seconds to
initiate the 802.11 FH card.
getvar result Returns the International mode.
Example Description This command instructs printer to
respond with current International
mode.
Syntax ! U1 getvar
“wlan.international_mode”
Result “off”
setvar choices “on”, “off”
Default “on” for 802.11 FH, “off” for 802.11b
Example Description This command instructs the printer
to turn on International mode.
Syntax ! U1 setvar
“wlan.international_mode” “on”
Result Sets the International mode to “on”.
To Next Page
Loading...