P14-84 Mobile Printer CPCLProgramming Manual
wlan.power_save
type: getvar ; setvar
This parameter refers to the power save modes which af-
fect power consumption of the network radio card in the
printer. Two radio cards are currently supported: SYM-
BOL and CISCO. The SYMBOL radio has a range of
power save modes from “1” (best throughput) to “best”
(best power save).
The CISCO radio has a fast power save mode and a full
power save mode (“best”). Any setting other than “best”
(“1”-”4”) sets the radio to fast power save and is not scal-
able. The “off” setting puts either radio into CAM (Con-
stant Awake Mode).
This parameter is not supported on units with a Frequency Hopping Spread
Spectrum (FHSS) radio as of this writing. Support is pending.
getvar result The printer responds with current power save
mode setting.
Example Description Instructs the printer to respond with
the value of the wlan.power_save
mode.
Syntax ! U1 getvar “wlan.power_save”
Result “off”
setvar choices “off”, “1”, “2”, “3”, “4”, “best”
Default “best”
Example Description Instructs the printer to set the value
of the power save mode.
Syntax ! U1 setvar “wlan.power_save” “2”
Result Changes the power save mode to
“2” if a Symbol radio is used, or
fast power save mode if a Cisco
radio is used.
To Next Page
Loading...