P15-10 Mobile Printer CPCLProgramming Manual
GAP-SENSE Command Example:
The following example configures the printer for gap-
sensing. In addition, it specifies that the distance from
top-of-form to the gap is zero.
Input (GAPSENSE.LBL):
! UTILITIES
GAP-SENSE
SET-TOF 0
PRINT
GAP-SENSE & BAR-SENSE Commands
These commands are used to instruct the printer as to
which means of top-of-form detection should be em-
ployed. Printers default to BAR-SENSE if no command is
specified. Printers that are not equipped with a gap-
sensor will attempt a pseudo gap-sense.
Format:
{command}
where:
{command}: Choose one of the following:
GAP-SENSE # (0-255)
BAR-SENSE # (0-255)
Gap and Bar Sense commands can be followed by a
number to adjust sensitivity. This is useful for gap sense
stock from vendors other than Zebra.
To Next Page
Loading...