P3-6 Mobile Printer CPCLProgramming Manual
USING FONT GROUPS
FONT-GROUP (FG) Command
The FG command gives a user the ability to group up to
10 pre-scaled font files into a single group. A user can
later specify the font group in a TEXT command. If a font
group is used in a text command, the printer will use the
largest
font specified in the font group that will produce
the required text data and still remain within the available
width of the label for the text. When specified in the
TEXT command, the {font} parameter is specified as FG,
and the {size} parameter is specified as the {fg}. Note
that a user can also specify an FG command within a
CONCAT/ENCONCAT command.
Format:
{command} {fg fn fs} [fn fs] ...
where:
{command}:
FG
{fg}:
Font group number. Up to 10 font
groups can be specified. Valid font
groups range from 0 to 9.
{fn}:
Name/number of the font.
{fs}:
Size identifier for the font.
NOTE: Up to 10 font number/font size pairs can be
assigned to a font group.
To Next Page
Loading...
