Zebra CPCL - SETMAG Command

P3-14 Mobile Printer CPCLProgramming Manual
SETMAG Command
The SETMAG command magnifies a resident font to the
magnification factor specified.
Format:
{command} {w} {h}
where:
{command}: SETMAG
{w}: Width magnification of the font.
Valid magnifications are 1 thru 16.
{h}: Height magnification of the font.
Valid magnifications are 1 thru 16.
NOTE: The SETMAG command stays in effect after
printing a label. This means that the next label
printed will use the most recently set SETMAG
values. To cancel any SETMAG values and
allow the printer to use its default font sizes, use
the SETMAG command with magnifications of
0,0.