61335M Main Logic Board Maintenance Kit
Remove the Old Main Logic Board (MLB)
52
61311L-001 Rev. A HC100 Maintenance Manual 5/8/08
6. Which communication option is being used?
If you have a… Then…
Wired Ethernet a. See Figure 28. Remove the wired ethernet board by removing
the three mounting nuts.
b. Slide the wired ethernet board off of the standoffs.
c. Remove the three standoffs from the old MLB.
d. Go to Install the New MLB on page 55.
Wireless Ethernet
a. See Figure 29. Remove the three mounting screws, spacers, and
nuts.
b. Remove the wireless ethernet board by pulling it out of
connector J1 on the MLB.
Note • Leave the antenna cable connected to the wireless ethernet
board.
c. Go to Install the New MLB on page 55.
Serial or USB port Go to
Install the New MLB on page 55.
To Next Page
Loading...
