Zebra HC100 - Page 70

61337M ZebraNet™ Internal Wireless Plus Print Server Assembly Kit
Remove the Main Frame and the Main Logic Board (MLB)
70
61311L-001 Rev. A HC100 Maintenance Manual 5/8/08
Figure 41 • Remove the Wireless Antenna
5. See Figure 42. Using a Phillips screwdriver, remove the MLB by removing the four
screws securing it.
6. Slide it to the rear and off of the guide post.
1
Antenna cable connector
2
Antenna bracket
3
Lock washer
4
Nut
5
Antenna
6
J16 connector
7
Wireless Plus Print Server board
8
Wireless cable
Note • In Figure 42, the print mechanism chassis and upper print mechanism cover have
been removed to improve the clarity of this figure. Your printer will still have these
assemblies attached.
1
2
7
6
3
4
5
8