29
Printer Setup
Preparing the Printer for Use
11/15/10 HC100 User Guide 61207L-002 B
Connect to Power Source and Turn on Power
After you connect to a data communication interface, you may connect the printer to a power
source and turn the power on.
To connect the printer to a power source and turn on the power, complete these
steps:
1. Locate the two parts of the power cord assembly. The power cord assembly consists of an
A/C power cord (
1) and a low-voltage D/C cord that is attached to a power supply (2)
(Zebra model number FSP070-RDBM). If an A/C power cord was not included with your
printer, refer to Power Cord on page 78 for specifications.
2. Insert the female end of the A/C power cord into the power supply.
3. Insert the low-power D/C cord into the D/C power connector on the back of the printer.
Caution • For personnel and equipment safety, always use an approved three-conductor
power cord specific to the region or country intended for installation. This cord must use an
IEC 320 female connector and the appropriate region-specific three-conductor grounded
plug configuration.
To Next Page
Loading...
