Advanced User Information
Changing and Restoring Printer Settings
58
61207L-002 B HC100 User Guide 11/15/10
Changing and Restoring Printer Settings
By default, the printer automatically adjusts the settings based on the type of media cartridge
that you insert. You will not usually need to adjust these settings. If necessary, you can adjust
the printer settings to obtain optimal print quality or to change connectivity parameters. You
do this through Zebra Programming Language II (ZPL II) commands, Set/Get/Do (SGD)
commands, or through the printer’s web pages. The printer requires an active wired or wireless
Ethernet connection for you to access the printer’s web pages.
For the ZPL commands and SGD commands, see the ZPL II Programming Guide. A copy of
this manual is available at http://www.zebra.com/manuals or on the user CD that came with
your printer. For instructions on accessing the printer’s web pages, see Web Pages on page 69.
Table 9 shows the printer parameters and what you can use to modify them.
Table 9 • Printer Parameters
Parameter Details
DARKNESS MODE Select Darkness Mode
The printer has three darkness modes, which determine how the DARKNESS
value is set.
Default Value: CARTRIDGE
Selections:
• CARTRIDGE—DARKNESS is set to the media cartridge default value. No
changes are allowed, and the printer ignores ZPL commands that change the
darkness value.
• USER—DARKNESS is set by the user, and the printer ignores the media
cartridge default value. This darkness value is used for all media cartridges
that are inserted into the printer.
• RELATIVE—DARKNESS is stored as the difference between the current
darkness setting and the current media cartridge default value. The printer
adds this difference to the default darkness value of any subsequent media
cartridges.
Corresponding ZPL Command: None
Corresponding SGD Command: media.darkness_mode
Located on Web Page: General Setup
To Next Page
Loading...
