63
Maintenance
Replacing the Printhead
4/1/09 LP 2824 Plus™ User Guide 980644-001 Rev. A
2. Slide the printhead to one side until it is free of the lid.
3. Use a #1 Phillips driver to loosen the screw that holds the ground wire to the bracket; pull
the wire away from the bracket.
4. Unplug both bundles of printhead wires from the left and right connectors.Use a #2
Phillips driver to remove the screw that holds the ground wire.
5. Gently but firmly pull the two printhead cable bundles’ connectors off of the printhead.
To Next Page
Loading...
