18 Zebra P330i & P330m Card Printer User’s Manual 980459-001 Rev D
Installation and Setup
Setting the Card Thickness Control
Setting the Card Thickness Control
The Card Thickness Control is set by the user to adjust the gap as cards enter the printer, to
prevent double-feeds (which could cause a jam) or mis-feeds.
Step 1. Open the Card Feeder cover. The cover is hinged; lift it by the lip at the right front
corner.
Step 2. The Card Thickness Control Lever is at the front of the left-side opening of the Card
Feeder area.
Note • Set the Card Thickness Control before loading cards.
Note • To reduce contamination and ensure better print quality, minimize the time the Card
Feeder cover is open.
Card Thickness
Control
To Next Page
Loading...
