28 Zebra P330i & P330m Card Printer User’s Manual 980459-001 Rev D
Printing a Card
Setting Printer Properties
Setting Printer Properties
Printer Properties can be set either at the Operating System level or within the application
software program used for printing cards.
Preferences settings can configure the printer for Landscape (wide) or Portrait (tall) printing
orientation, and allow the user to verify that the desired ribbon is installed in the printer.
(Monochrome ribbons are selected via the drop-down menu.)
If the printer includes the optional magnetic card stripe encoder, encoding parameters and
coercivity can be set.
Printer cleaning can be initiated from the Tools window (printer cleaning can also be initiated
at the printer; see Chapter 4).
Also from the Tools window, the Test Card can be selected from several pre-loaded styles.
“Single Feed Options” allows Disabling or Enabling Single Feed Support.
• If “Disable Single Feed Support” is selected, when the printer runs out of cards in the
feeder, the LCD display will read OUT OF CARDS. To continue, press the panel
button.
• If “Enable Single Feed Support” is selected, when the printer runs out of cards in the
feeder it will wait until a card is inserted in the single-card slot or cards are loaded in
the feeder, and then will automatically continue.
Note • In the following description of setting Printer Properties, only those properties
and options that are suitable for being set by the User are described. The User should not
make selections or set parameters unless they are specifically described in this section
To Next Page
Loading...
