• 2-19 • RMAN-P4T-001 rev. A • P4T/RP4T Repair Procedures
5. Peel the backing off the bar sensor cable and adhere it in the groove on the
bottom of the Printer Frame with the cover open.
6. Plug the Bar Sensor Cable to the connector at J6 on the CPU Board.
7. Install the Printer Frame in the Lower Housing. Avoid putting excess strain on
the remaining cables connected to the CPU Board.
8. Install the Upper Housing into the Lower Housing and secure the five screws on
the bottom of the printer and two screws under the media cover.
9. Reinstall the battery
To Next Page
Loading...
