RMAN-P4T-001 rev. A • P4T/RP4T Repair Procedures • 2-40 •
Replacement Kit RK18931-011
LCD Display
Installation Instructions
This kit includes the parts and documentation necessary to install the RK18931-
011 LCD Display in the P4T/RP4T model printers. Read these instructions
thoroughly before attempting to install this kit.
Tools Required
#0 or #1 Phillips Head Screw Driver
Removing the LCD Display
1. Separate the Upper Housing from the Lower Housing as previously described.
2. Remove the Main Logic Board from the Upper Housing as described
previously.
3. Disconnect the 802.11g and Bluetooth radio antennas from the antenna
boards.
4. Remove the two (2) self-tapping screws located on the printer frame above the
antenna boards as shown below.
5. Remove the screw on the left side arm of the Upper Housing above the gear
retainer cover.
6. Remove the screw on the opposite side arm of the Upper Housing next to the
green latch release button and detach the Upper Housing from the printer.
To Next Page
Loading...
