• 2-39 • RMAN-P4T-001 rev. A • P4T/RP4T Repair Procedures
Installing the 802.11g and Bluetooth Radios
1. Vertically align the Bluetooth Radio Board with the corresponding mounting
holes on the MLB, ensuring that the antenna cable is pointing down.
2. Secure the PCBA to the MLB using the provided three (3) screws and connect
the antenna cable to the antenna board.
3. Horizontally align the 802.11g Radio Board with the corresponding mounting
holes on the MLB, ensuring the antenna is pointing down.
4. Secure the PCBA to the MLB using the provided three (3) screws and connect
the antenna cable to the antenna board. Route the cable behind the plastic clip to
secure as shown in the inset above.
To Next Page
Loading...
