Zebra P4T - Page 16

37537 8VHU*XLGH
16
,QVWDOOLQJWKH376HULHV%DWWHU\3DFN
Important • New battery packs are shipped
uncharged. Remove any protective shrink-
wrap and labels from a new battery pack
prior to use.
Additional battery packs may be ordered
using Zebra p/n AK18913-001.
If you are using an LI72 single charger
or the LI72-4 Quad Charger, you must
charge the battery prior to installing it in
the printer.
,QVHUWWKHEDWWHU\SDFNLQWRWKHSULQWHUDV
VKRZQLQ)LJXUH
5RFNWKHEDWWHU\SDFNLQWRWKHSULQWHUDV
VKRZQXQWLOLWORFNVLQSODFH
 ,I\RXDUHXVLQJWKH$&DGDSWHU\RXVKRXOG
DOORZWKHEDWWHU\SDFNWRFKDUJHFRPSOHWHO\
SULRUWRXVLQJLWIRUWKHILUVWWLPH
:KHQDQHZEDWWHU\SDFNLVILUVWLQVWDOOHGWKH
&RQWURO3DQHOLQGLFDWRUVPD\EULHIO\WXUQRQDQG
WKHQ JR RII LQGLFDWLQJ WKH EDWWHU\ LV QRW IXOO\
FKDUJHG 5HIHU WR WKH Charging the Battery DQG
Operator ControlsWRSLFVLQWKLVPDQXDO
Figure 6: Installing the P4T Series Battery Pack
Section Continues
P4T Series
Battery Pack
Insert this side of the
battery pack into the
bottom of the printer as
shown.
Rock the battery pack
until it clicks into place.
Charger port for use
with the P1026943-1
AC Adapter
Printer Preparation
pg. 7
Connecting the
Printer pg. 27
Radio Regulatory
Information pg. 31
RP4T Printers pg.
35
Maintenance pg. 36
Troubleshooting pg.
38
Specications pg.
43
Appendices pg. 46 Index pg. 52
P4T Overview-
pg. 5
Manual
Introduction pg. 4