4
Loading Labels:
1. Perform the AutoSense adjustment when loading a new roll of labels.
2. Open printer cover.
3. Open green label holder.
4. Load labels face up into holder and thread through the black label guides.
Adjust label guide by using the green control wheel (on right). Do not over
tighten since labels will not feed freely and properly. (See page 3.)
5. Once tightened, release cover and shut. Press the feed button on top of
machine.
Opening the printer
To access the media compartment, you
must open the printer.
Pull the release levers towards you and lift
the cover.
To Next Page
Loading...
