5
Loading Ribbon:
See page 6 for diagram.
• Open printer cover. Pull ribbon carriage forward.
• Attach ribbon roll to spring load closest to back of printer. Make certain the notches on the ribbon
core and the notches on the machine are matching up together on the left side (see next
page). Continue to wrap ribbon under and up until sufficient ribbon is extended to reach the empty
cardboard core in the front spring load.
• Attach adhesive end of ribbon to cardboard ribbon core. Load this roll in the spring load located in
the front of the printer.
• Using the roll control (on left) turn clockwise until ribbon shows only black.
• Push print head back up into top of the cover and close cover.
Always retain the cardboard core since you will need it each time you replace your ribbon.
Please note that ribbons are not reusable!
To Next Page
Loading...
