6
Loading Ribbon continued…
Install the ribbon supply roll.
Install the take-up roll.
Attach the ribbon.
Tighten the ribbon.
Before following these steps, prepare the
ribbon by removing its wrapping and
pulling its adhesive strip free.
1.Thread the ribbon through the
carriage.
2.Press the right side onto the supply
hub.
3.Align the notches on the left side and
mount onto the spokes of the left hub.
1.Press the right side onto the take-up
hub.
2.Align the notches on the left side and
mount onto the spokes of the left hub.
You can find your first ribbon take-up
core in the packing box. Subsequently,
use the empty supply core to take up the
next roll of ribbon.
1.You must align the ribbon so that it will
be taken straight onto the core.
2.Attach the ribbon to the take up core.
Use the adhesive strip on new rolls;
otherwise, use tape.
1.Turn the ribbon take-up gear
counter-clockwise (top moves toward
rear) to remove slack from the ribbon.
2.Close the top cover. Remember that
you need to release the cover lock,
lower the top cover, and press down
until the latches snap into place.
1
2
3
4
To Next Page
Loading...
