Zebra TLP 2824 Plus - Document Conventions

7
Perform AutoSense Adjustment
AutoSense Adjustment must be performed each time a new roll of labels or ribbon is loaded.
Note: Printer prints
“out of DUMP”
Power unit OFF and
then ON. Then press
Green button.
Unit will normally use 15 to 20 labels to complete the adjustment.
1
1
2
2
3
3
4
4
Make sure power is
on and light is green.
Press & hold green
button down while
watching the light for
flash sequence.
Green light will flash
once then go solid.
Then it will flash twice
& go solid. Release
button after it flashes
twice.