8
How to Set Up the New System:
1. Plug power supply into power cord then into back of printer and into power outlet.
2. Plug keypad into back of printer and tighten screws securely.
3. Flip the ON/OFF power switch to the ON position. The switch is located on the right side near the back
of the printer. A green light will appear when printer is ON. Never unplug the printer before turning the
power switch to the OFF position.
4. Load Labels.
5. Check to make sure ribbon is fully in place and tight. It could loosen during shipping.
6. Run a test print by following directions on page 9. The first one or two labels will print out of alignment.
The third label should print like the sample labels.
Plug
Varies b
Country
AC
Power
Cord
Power
Supply
Power
Switch
Power
Supply
Receptacle
Barrel
Connector
To Next Page
Loading...
