Zebra Z4Mplus Maintenance Manual

13358L Rev. 1 11/17/03 Z4Mplus and Z6Mplus Maintenance Manual 3
System Description Section 1
Bar Codes
Standard Printer Fonts
Fonts A, B, C, D, E, F, G, H, and GS are expandable up to 10 times, height and width
independently. However, fonts E and H (OCR-A and OCR-B) are not considered
“in-spec” when expanded.
The scalable smooth font 0 (CG Triumvirate™ Bold Condensed) is expandable on a
dot-by-dot basis, height and width independent, while maintaining smooth edges.
Maximum character size depends on available memory.
IBM Code Page 850 international character sets are available in the fonts A, B, C, D, E, F,
G, P, Q, R, S, T, U, V, and 0 through software control.
• Bar code ratios – 2:1, 7:3, 5:2, and
3:1
•ISBT-128
• Codabar (supports ratios of 2:1 up
to 3:1)
• LOGMARS
• MaxiCode
• CODABLOCK • Micro PDF
•Code 11 •MSI
• Code 39 (supports ratios of 2:1 up
to 3:1)
• PDF-417 (2-dimensional bar code)
• Plessey
• Code 49 (2-dimensional bar code) • POSTNET
• Code 93 • QR-Code
• Code 128 (with subsets A, B, and C
and UCC case C codes)
• Standard 2 of 5
• UPC-A, UPC-E, UPC extensions
• Data Matrix • Check digit calculation where
applicable
• EAN-8, EAN-13, EAN extensions • Industrial 2 of 5
• Interleaved 2 of 5 (supports ratios
of 2:1 up to 3:1, Modulus 10 Check
Digit)
•RSS
•Planet Code B5

Zebra Z4Mplus Specifications

General

Print Method	Thermal transfer or direct thermal
Resolution	203 dpi
Max Print Width	4.09 inches
Max Print Length	39 inches
Max Print Speed	10 inches per second
Memory	4 MB Flash, 8 MB DRAM
Interface	Parallel, Serial
Media Sensors	Reflective and transmissive
Media Width	0.79 inches to 4.5 inches
Media Length	0.38" (9.6 mm) to 39" (991 mm)
Ribbon Width	2 inches to 4.33 inches
Power Requirements	100-240 VAC, 50/60 Hz
Operating Temperature	40°F to 105°F
Storage Temperature	-40 to 140°F (-40 to 60°C)
Humidity	20 to 85% non-condensing