1400 Industrial Way, Redwood City, CA 94063
P: 800.800.5655 F: 650.556.2240
How to Install and Configure Your Label Printer
Zebra ZD410
First, load labels into your Label Printer, plug in the power cord, and plug the USB cord from
the printer to your computer as seen in the picture below, then click ‘Next’.
Run Zebra Setup Utilities
Click 'Next' to install the pre-loaded drivers.
Install Zebra Setup Utilities on the computer you will be installing the printer on by running
ZebraSetupUtilities.exe from the thumb-drive provided by Ascend
To Next Page
