11
7026
Flipper Card Jam
What Was The Printer Doing
When The Problem
Occurred?
Is the Flipper Roller Popped
Out Of Place On the Flipper
Deck?
(See Pic 1.0)
No
Refer to the Service
Manual to Replace
Flipper Roller
Yes
Initializing?
Pg. 10
Manual Card Feed
Slot
Card
Feeder
Is The Flipper
Deck Level w/ The
Card Path?
Are The Cards
Trying To Feed At
The Same Time?
Is the Card
Jamming Between
the Feeder and
the Flipper?
(See Pic 1.2)
Is The Flipper Deck Level w/
Feeder Position? (Cards
Feeding Either In Front Of Or
Behind Flipper Deck)
Yes
No
No
Turn Off Printer, Remove Card
From Flipper, Then Restart
Printer And Feed Cards
YesNo
Turn Printer Off, Remove
Feeder Cartridge And Open
Options Door. Remove Jammed
Card. Restart Printer and Print
card again.
Yes
Turn Printer Off, Open Options
Door, Remove Cleaning
Cartridge, Clear Flipper Jam,
and Fan Out Remaining Cards
to Separate them. Restart Job
Yes
Done
Card
Jams
Card
Prints
Make Sure Feeder Cartridge Is
Pushed All The Way To The
Left (See Pic 1.3)
Make Sure The Cleaning
Cartridge Is Inserted Correctly,
(See Pic 1.4) Then Print Card
Again
Then
Check To See If Singulation
Roller Is Worn.
(See Pic 2.0)
Also
Still
Jams
Card
Prints
No
Attempting to feed cards
.
How Were You Feeding The
Cards?
Printing?
Pg. 13
Card
Prints
Card Jams
Send Printer For
Service Pg. 14
Done
Card
Feeds
Flipper
Jams
Flipper
Jams
Continue
on Pg. 12
Done
Done
Continue
on Pg. 12
Pg. 10 Flipper Jam When Initializing
Pg.11 Flipper Jam When Feeding Part 1
Pg. 12 Flipper Jam When Feeding Part 2
Pg.13 Flipper Jam When Printing
Pg.14 Service Center Instructions
Pg. 15 Reference Page Part 1
Pg. 16 Reference Page Part 2
To Next Page
Loading...
