36
17013/ 17014
Top/ Bottom Heater Fail
Turn the printer off and back
on. Allow the printer and
laminator to reinitialize and
the job to restart.
Re-seat the laminator oven. To do this, turn off
the printer. Open the laminator doors and
remove the 4 screws holding the laminator oven
in the laminator (See Pic 2.1). Pull the laminator
oven out and put it back in. Replace the screws,
close the laminator doors and turn the printer on.
Job should resume.
Send to Service
Center
Pg. 39
Done
Card
Laminates
Error Comes Back
Error Comes Back
Done
Card
Laminates
Make sure path under
heater is clear. (See Pic
2.0). If card or laminate
debris found, power cycle
the printer and resume
laminating job.
Error Comes Back
Done
Card
Laminates
Pg. 35 Laminate Feed Fail
Pg. 36 Laminate Heater Fail
Pg. 37 Laminate Cutter Fail
Pg. 38 Service Center Feed Fail
Pg.39 Service Center Heater Fail
Pg.40 Service Center Cutter Fail
Pg. 41 Reference Page Part 1
Pg. 42 Reference Page Part 2
Replace heater using Kit
Heater Assembly ZXP7
105936G-519. Refer to
service manual for install
instructions. Attempt to print
and laminate a card.
DoneNo Heater Fail
Error Comes Back
Make sure the most up to
date laminator FW is
installed. If not, load it, then
power cycle printer. Attempt
a printing and laminating job.
DoneNo Heater Fail
Error Comes Back
To Next Page
Loading...
