Introduction
Thanks for purchasing the Zeez F7 flight controller.
This board is being designed and developed by pilots for pilots.
Zeez Design project was born in Italy in early 2016 from FPV
racing pilots and students of the Engineer University of Bologna
that wanted to develop their own gear for racing drones.
The ZeeZ F7 flight controller is our first product. In this project
we thought about the most common drama that happen in FPV
quad...wires break and big difficulties to stack all electronics in
our quad.
Here we have really easy assembly (and if you are using some
VTX or RX you just have the wires from the FC to the FPV
Cam) that will result in clean and low profile stack.
Specification:
●Up to 8S input (max 36V)
●5V BEC up to 3A continuous
●STM32F722 MCU
●MPU6000 Gyro/ACC for smooth performace
●128MB OnBoard flash
●OSD chip Onboard
●6 available UARTS
●VTX switch to control the ON/OFF of the VTX
directly from your transmitter
●LC Filter for 5V VTX
●USB Type C connector
●Onboard RGB LED distribution for clean wiring
to the LED on the arm of the quad.
●Onboard RBG LED
●Notch desing on sides and in the front of the FC
for better fitting on the frame.
⑵
To Next Page
Loading...
Need help?
General