Zendure AB2000S - Maintenance and Important Information; Parts and References; Whats in the Box

11
EN
Add-on Battery AB2000S
5. Parts and References
5.1 What’s in The Box
User Manual
Do not place AB2000S in direct sunlight.
Product and component images may differ from actual products. If any parts
are missing or defective, please contact Zendure customer support.
The AB2000S will forcibly implement a discharge lower limit of 5% in
the following situations:
• Battery temperature < -5° C
• Battery temperature < 0° C for 30 mins
This can prevent over-discharging of the AB2000S and extend the
battery life.
It is recommended to use AB2000S in an environment at 15℃ ~30℃ ,
away from water, re and other sharp objects.
For long-term storage, please charge and discharge AB2000S once
every 3 months. That is, discharge AB2000S to 30% SOC rst, and then
recharge it to 60% SOC.
When using for the rst time, please remove the charge and discharge
limit of the battery, and then perform the following cycle once:
discharge the battery to 0%, then charge it to 100%.
If the power of AB2000S is lower than 1% SOC after use, please charge
it to 60% SOC before storing it. Leaving the battery discharged for a
long time can cause irreversible damage to the battery and shorten
the service life of AB2000S.
Do not disassemble AB2000S. When service or repair is required,
please consult ofcial Zendure channels. Improper disassembly or
reassembly may result in a risk of re or personal injury.
4. Maintenance and Important Information
60%
Mounting kit