Zephyr ALU-E43ASX - Wiring (External and In-Line Blower)

- 25 -
WIRING (EXTERNAL AND IN-LINE BLOWER)
1. Run 4-wire plus ground power cable from the remote blower to the remote blower wiring
box marked “motor connection” (Fig.34).
2. Feed 6” of cable through the knockout opening and secure the cable to the wiring box with
an appropriate connector.
3. Make electrical connections at the hood (box marked 120 Vac input). Connect white-to-
white, black-to-black, green-to-ground (Fig.34).
4. Make electrical connections (remote blower box marked “motor connection”). Connect
white-to-white, black-to-black, blue-to-blue, red-to-red, green-to-ground.
5. Fix the wiring box covers and screws. Make sure wires are not pinched between the cover
and box.
External blower connection:
1. Make electrical connections at the remote blower (see instructions provided with the
remote blower).
FIG.34
REMOTE BLOWERHOOD WIRE
HARNESS
BOX MARKED
“120 VAC INPUT”
REMOTE BLOWER BOX
CONNECT:
WHITE-TO-WHITE,
BLACK,-TO-BLACK,
GREEN-TO-GROUND.
(2) MOUNTING
SCREWS (3.9 x 6
mm Flat Head)
WHITE(COMMON)
BLACK(HIGH)
BLUE(MED)
RED(LOW)
GREEN(GROUND)
CONNECT:
WHITE-TO-WHITE,
BLACK-TO-BLACK,
BLUE-TO-BLUE
RED-TO-RED
GREEN-TO-GROUND.