15
8. Programming: New transmitter to T60 receiver.
Applies DA variety of 6 - channel radio.
Erase old transmitters
1. Open lid at receiver.
2. Push-button (12 & 13) at the same time,
red LED shines with a permanent light. Keep
button down until red LED stops shining.
The erase is completed.
Program new transmitters
3. Push button (12) red LED is lit. Release
the button, red LED shines with a permanent
light.
4. Push button(13) 3 times in a row, this must
be started before red LED (3) stops shining
(5 sec.) Red LED (3) blinks.
5. Push button (1) at your new transmitter,
red LED (3) blinks 3 times.
The receiver is now programmed!
6. Perform a test by push one or some but-
tons.
If you contrary to expectations not get
your system to function. Please contact
your dealer.
1
2
3
4
5
To Next Page
Loading...