To Next PageTo Next PageWhy is the range of my Zepro T60 too short?
A short range in your Zepro Control Unit could be due to a weak battery or improper installation. Ensure the system is correctly installed according to the installation instructions.
What to do if Zepro T60 Control Unit receiver doesn't function at transmitting?
If the receiver of your Zepro Control Unit isn't transmitting, it might not be installed correctly or it may have the wrong operating voltage. Check the installation of the receiver.
What to do if my Zepro Control Unit's tail lift remains still, but the transmitter functions normally?
If the transmitter of your Zepro Control Unit seems to be working, but the tail lift remains still, it's possible that the + and - wires were mixed up during installation. Try switching the + and - wires.
What to do if the green LED no:2 on the Zepro T60 Control Unit receiver shines despite there’s no transmitting?
The green LED no:2 shining on your Zepro Control Unit receiver without transmitting indicates that another radio control unit in the area might be using the same frequency. Test the system in another location. If the problem persists, contact your dealer.
What to do if the green LED no:2 on the Zepro T60 receiver doesn’t shine at transmitting?
If the green LED no:2 on the receiver of your Zepro Control Unit doesn’t shine when transmitting, the battery in the receiver may be dead, or the transmitter might be broken. Replace the battery or contact your dealer.
General| Brand | Zepro |
|---|---|
| Model | T60 |
| Category | Control Unit |
| Language | English |
Emphasizes reading the manual before installation for optimal system use and longevity.
Lists the components included in the delivery box for the Zepro T60 system.
Details on Zepro T60 frequency, composition, and factory encoding for security.
Instructions for optimal Zepro T60 receiver installation, including cable direction and mounting.
Shows how to mount the angle sensor on different lift models for proper function.
Highlights the critical safety role of the angle sensor and warns against modification.
Shows wiring for ZePro1 controler card, firmware 8.0 or later, without connection card.
Reference table for connecting various lift models to the control system.
Illustrates connections for ZePro1 controler card, firmware 7.0 or earlier, with connection card.
Detailed wiring schematic for radio control unit connections on the lift.
Specific diagram for connecting radio control unit with a connection card.
Explains the function assigned to each cable color for the 4-channel radio.
Details how to use the lock/unlock feature and its behavior with power cycles.
Defines the function for each cable color in the 8-channel radio system.
Explains the lock/unlock mechanism for the 8-channel transmitter and its power retention.
Provides an explanation of the LEDs and their meanings on the 4-channel radio circuit card.
Explains the LEDs and their functions on the 8-channel radio circuit card.
Step-by-step guide to erasing previously programmed transmitters for 3/4-channel systems.
Procedure for programming new transmitters to the T60 receiver for 3/4-channel systems.
Instructions to erase existing transmitters for the DA variety of 6-channel radio.
Procedure for programming new transmitters to the DA 6-channel receiver.
Lists common receiver issues, their possible causes, and suggested corrections.
Addresses problems with transmission range, relay clicks, and tail lift response.
