16
Malfunction Possible cause Correction
The receiver does not func-
tion at transmitting.
The receiver isn’t properly
installed. The receiver has
got wrong operating voltage.
Check installation of the
receiver.
The green LED no:2 on the
receiver shines at transmit-
ting, but the relay doesn’t
functioning.
The code in the transmit-
ter isn’t the same as in the
receiver.
Contact your dealer.
The green LED no:2 on
the receiver shines despite
there’s no transmitting.
There is an another radio
control unit in the area at the
same frequency in use
Test the system at a another
place. If the problem re-
mains, contact your dealer.
The green LED no:2 on the
receiver doesn’t shine at
transmitting.
The battery in the receiver is
nished. The transmitter is
broken.
Change the battery or con-
tact your dealer.
The range is to short. The battery is poor. The
system isn’t installed prop-
erly according to installation
instructions.
Check out that the system is
installed properly according
to installation instruction.
It seems that the transmit-
ter is functioning normally.
The relay inside the receiver
clicks, but the tail lift re-
mains still.
+ and - is mixed up at instal-
lation.
Shift + and -
9. Troubleshooting.
To Previous Page
Loading...