14
1. Open lid at receiver.
2. Push button on receiver circuit card for programming new transmitter (see page 8 and
9), whereupon red LED (3) shines with a permanent light. Keep button down at least 6 sec.
until red LED stops shining.
3. All old memorized transmitters are now erased from the memory in the receiver.
8. Programming: New transmitter to T60 receiver.
Erase old transmitters
4. Push button on receiver circuit card for programming new transmitter (see page 8 and
9), whereupon red LED (3) shines with a permanent light.
5. Release the button.
6. When button is released, the red LED (3) shines with a permanent light.
7. When the red LED (3) shines permanent, push an optional button on the new transmit-
ter until red LED (3) blinks. This must be started within 6 sec.
8. The transmitter is now programmed at the receiver, perform a test by push one or some
buttons.
If you contrary to expectations not get your system to function. Please contact your
dealer.
Note! All steps below must be carried out
Applies all 3 / 4 - channel radio and DC / DF varieties of T60 receiver
Program new transmitters
To Next Page
Loading...