Troubleshooting
7.1
TroubleshootingTroubleshooting
Electric Motorcycle Precautions
Your Zero Motorcycle has high voltage components. The high
voltage used by these components is dangerous and can cause
personal injury, severe burns, electric shock and even fatal
injury unless appropriate precautions are taken.
Always observe and obey the instructions on labels attached to
components on the vehicle - they are there for your safety.
Do not touch, attempt to remove or replace any high voltage
parts, wiring (identified by the orange outer sleeving) or
connectors. If the motorcycle is involved in an accident do not
touch any high voltage wiring connectors or the components
connected to the wiring. If a motorcycle fire occurs, extinguish
visible flame with a Class D power-type fire extinguisher. After
flame has extinguished, douse with a water-based fire
extinguisher.
WARNING! Your motorcycle uses high voltage. System
components can be too hot to touch during and after starting
and when the motorcycle is shut off. Be careful of both the high
voltage and the high temperature. Obey all labels that are
attached to the motorcycle.
WARNING! The motorcycle’s high voltage system has no user
serviceable parts. Disassembling, removing or replacing high
voltage components, cables or connectors can cause severe
burns or electric shock that may result in serious injury or death.
High voltage cables are colored orange for easy identification
(see First Responder Information at the back of this manual).
Troubleshooting Your Motorcycle
All of the motorcycles are carefully inspected before they are
delivered. Even after the motorcycles are inspected, some
technical issues can occur. The following information offers a
guide to help you to identify an issue, and if possible, repair it
yourself. If you are unable to solve an issue with your Zero
S/SR/DS/DSR electric motorcycle, take it to an authorized
dealer at your convenience. If there is no dealer in your area call
Zero Motorcycles Customer Service.
Zero Owner's Manual (S and DS).book Page 1 Monday, September 21, 2020 11:43 AM
To Next Page
Loading...
