General Operation
4.3
OFF Position
This position is used to turn the motorcycle OFF, disabling the
electrical system.
ON Position
This position is used for operating the motorcycle. In this
position the following sequence occurs:
• Lights turn ON
• Dash display turns ON
Motorcycle Tip-Over Sensor
Your motorcycle has a tip-over sensor that will disable the
motorcycle’s drive mode in the event it is activated. If your
motorcycle’s tip-over sensor is activated:
• The motorcycle drive mode will be disabled while tipped-over.
• The motorcycle can’t be driven or charged while in a
tipped-over state.
• Upright the motorcycle and perform one full key cycle (turn
the key to the OFF position, wait for the display to go blank
and then turn the key back to the ON position) to reset the
sensor.
Note: Altering the factory suspension or changing the location
of the MBB (Main Bike Board) may cause either detection of a
false tip-over state or disable the detection in the case of an
actual tip-over.
Zero Owner's Manual (S and DS).book Page 3 Monday, September 21, 2020 11:43 AM
To Next Page
Loading...
